-
-
C-band Pulse EDFA
High-speed pulsed erbium-doped fiber amplifier is widely used for high-speed optical fiber communications, all-fiber sensing applications. The pulsed EDFA module has built-in drive circuit and logic control circuit to monitor key information such as pump laser temperature, module temperature and signal gain in real time. The module is configured to work at APC/ACC/AGC mode. All module state parameters and configuration information can be flexibly adjusted and monitored by upper computer software.
Features
High output peak power
High reliability
Low noise figure
Low pulse signal deformation
Flexible control mode
Excellent thermal adaptability
Support customization
C-band Pulse EDFA spec.pdf
Parameter | Unit | Minimum | Typical | Maximum | |
Wavelength Range | nm | 1528 | - | 1563 | |
Input Peak Power | dBm | -20 | 1 | 10 | |
Output Peak Power | W | - | - | 20 | |
Pulse Width | ns | 10 | 100 | 200 | |
Repetitive Frequency | KHz | - | 2 | - | |
Polarization Dependent Gain | dB | - | - | 0.5 | |
Polarization Mode Dispersion | ps | - | - | 0.5 | |
Noise Figure | dB | - | 5.5 | - | |
Input / Output Isolation | dB | 40 | - | - | |
Operating Temperature Range | ℃ | -20 | - | +60 | |
Storage Temperature Range | ℃ | -40 | - | 85 | |
Humidity | % | 5 | - | 90 | |
Power Supply | DC+5V GND | ||||
Fiber Connector | FC/APC or custom design | ||||
Fiber Type | SMF28 | ||||
